Extron electronic Ultra Series - Manual (Page 42)

Installation, cont’d
CrossPoint / MAV Matrix Switchers • Installation 2-20
Front Panel Configuration Port
(Matrix Sizes up to 1616 Only)
AUDIO VIDEO
I/O CONTROL
ENTER PRESET VIEW ESC
CONFIG
ULTRA-WIDEBAND MATRIX SWITCHER WITH ADSP ™
CROSSPOINT ULTRA SERIES
13
Figure 2-24 — Front panel configuration port
m
Configuration port — This 2.5 mm mini stereo jack serves the same serial
communications function as the rear panel Remote port, but it is easier
to access than the rear port after the matrix switcher has been installed
and cabled. The optional 9-pin D to 2.5 mm mini jack TRS RS-232 cable,
part #70-335-01 (figure 2-25), can be used for this connection.
6 feet
(1.8 m)
Part #70-335-01
5
1
9
6
Sleeve (Gnd)
Ring
Tip
9-pin D Connection TRS Plug
Pin 2 Computer's RX line Tip
Pin 3 Computer's TX line Ring
Pin 5 Computer's signal ground Sleeve
Figure 2-25 — Optional 9-pin TRS RS-232 cable
N This port is independent of the rear panel Remote port and is not affected by
changes to the rear panel port’s protocol. This front panel port’s protocol can be
changed, under SIS command control only. See the Command/Response table
for IP SIS commands, in chapter 4, “Programmer’s Guide”, to configure all
ports under SIS control.