Extron electronic Ultra Series - Manual (Page 149)

5-13 CrossPoint / MAV Matrix Switchers • Matrix Software
Updating firmware
The firmware upgrade utility provides a way to replace the firmware that is coded
on the switcher’s control board without taking the switcher out of service.
N The Firmware Loader must be installed on your computer to perform this
operation. Extron recommends that you install this program when you install
the Matrix Switchers Control Program. If you did not, it can be downloaded
from the Extron Web site, www.extron.com, and installed separately.
N The update firmware utility is for replacing the firmware that controls all
switcher operation. This is not the page to insert your own HTML pages.
See “Uploading HTML files”
to insert custom HTML pages.
Update the switcher firmware as follows:
1 . Visit the Extron Web site, www.extron.com, click the Download Center tab,
and then click the Firmware link (figure 5-9).
3
2
3
1
1
Figure 5-9 — Location of firmware upgrade files
2 . Select the appropriate firmware file to download and click Download.
3 . Enter the requested personal information and then click Download to copy the
firmware to your computer.
4 . Click Run twice (figure 5-10 on the next page). The PC downloads the
firmware update from the Extron Web site and starts the Extron Installation
Program to extract the firmware file.