Extron electronic Ultra Series - Manual (Page 175)

6-13 CrossPoint / MAV Matrix Switchers • HTML Operation
Creating or deleting a tie
Make or break a tie as follows:
1 . Click the Video Only, Audio Only, or Video & Audio button to select video,
audio, or both for switching (audio breakaway or audio follow). Each mouse
click on a button toggles the other two buttons off.
2 . Move the mouse over the matrix of input and output selection buttons. Click
a button to
• Create a pending tie (if a tie does not exist) of the input and output
associated with that button
• Create pending untie (if a tie exists) of the input and output associated
with that button
A “P” (for pending) appears in the button.
N If you lose track of the input and output associated with a specific button, let the
mouse rest over one of the tie buttons for a moment. A field pops up (as shown
on figure 6-10) that identifies the input and output for that button.
N To tie an input to all outputs, click that input’s input number.
3 . Click the Take button to make the configuration changes or the Cancel button
to abandon the configuration changes.
RGB and Audio Settings page
The RGB and Audio Settings page provides a way to set the input audio gain and
attenuation, set the output volume, mute and unmute all video and audio outputs,
and (for CrossPoint switchers only) set the RGB delay (switching interval). Access
the RGB and Audio Settings page (figure 6-11) by clicking the RGB & Audio
Settings link on the Control page.
Set and View Ties
Global Presets
Refresh
Figure 6-11 — RGB and Audio Settings page