Extron electronic Ultra Series - Manual (Page 154)

Matrix Software, cont’d
CrossPoint / MAV Matrix Switchers • Matrix Software 5-18
Uploading HTML files
You can create customized HTML pages for the switcher to display. The HTML
Files List window (figure 5-14) provides a way to view the contents of the
switcher’s file system and to upload custom HTML pages to the switcher.
Figure 5-14 — HTML Files List window
Upload HTML pages as follows:
N The files listed in figure 5-14 are shown for example only and may not be present
on your switcher.
N The HTML Files List window is for inserting your custom HTML pages. This
is not the window to replace the firmware that controls all switcher operation.
See “Updating firmware
”, earlier in this chapter, to replace the firmware.
N The following characters are invalid in file names:
{space} + ~ , @ = ‘ [ ] { } < > ’ “ ; : | \ and ?.
1 . Connect the PC to the CrossPoint or MAV switcher via either serial port or the
LAN port.
2 . Start the Matrix Switchers Control Program and connect to the
CrossPoint or MAV switcher. See “Using the Matrix Switcher Control
software” in this chapter, steps 1 through 4, starting on page 5-4.
3 . Click on Tools > HTML File Manager.
4 . Click the Pick File(s) to Load to Server button. An open file window
appears.
5 . Navigate to the folder where you saved the HTML file(s). Select the file(s).
N To select multiple files, hold the Ctrl key while you select the desired files.
N If you want one of the custom HTML files that you created to be the default
start-up page, name the file “index.html”. The switcher looks for that file name
when you first connect to it using an Internet browser.
6 . Click the Open button. The file(s) upload to the CrossPoint or MAV switcher
may take a few minutes.
7 . Click the Update button to confirm the upload.
8 . Click the Close button to exit the HTML Files List window.