Extron electronic Ultra Series - Manual (Page 184)

CrossPoint / MAV Matrix Switchers • Ethernet Connection A-2
Ethernet Connection
Ethernet Link
The rear panel Ethernet connector on the
CrossPoint or MAV switcher can be connected to an
Ethernet LAN or WAN. This connection makes SIS control
of the switcher possible using a computer connected to the
same LAN.
Ethernet connection
The Ethernet cable can be terminated as a straight-through cable or a crossover
cable and must be properly terminated for your application (figure A-1).
• Crossover cable — Direct connection between the computer and the
CrossPoint or MAV switcher.
• Patch (straight-through) cable — Connection of the CrossPoint or MAV
switcher to an Ethernet LAN.
Side
RJ-45
connector
Patch (straight) cable
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-orange
2 Orange 2 Orange
3 White-green 3 White-green
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Green
7 White-brown 7 White-brown
8 Brown 8 Brown
Crossover cable
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-green
2 Orange 2 Green
3 White-green 3 White-orange
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Orange
7 White-brown 7 White-brown
8 Brown 8 Brown
Insert
twisted
pair wires.
Figure A-1 — RJ-45 connector pinout tables
Default address
To access the CrossPoint or MAV switcher via the LAN port, you need the
switcher’s IP address. If the address has been changed to an address comprised of
words and characters, you can determine the actual numeric IP address using the
Ping utility. If the address has not been changed, the factory-specified default is
192.168.254.254.
Ping can also be used to test the Ethernet link to the CrossPoint or MAV switcher.
A
CT
L
IN
K
E
TH
E
R
N
E
T