Extron electronic Ultra Series - Manual (Page 101)

3-57 CrossPoint / MAV Matrix Switchers • Operation
Performing soft system resets (resets 3, 4, and 5)
Perform a soft reset of the switcher as follows:
1 . Use an Extron Tweeker or other small screwdriver to press and hold the rear
panel Reset button until the front panel Video and Audio buttons blink once
(events reset), twice (system reset), or three times (absolute reset) (figure 3-82).
I / O
RGBHV AUDIO
RESET RESET RESET
I / O
RGBHV AUDIO
RESET RESET RESET
I / O
RGBHV AUDIO
RESET RESET RESET
Release, then immediately
press and release again.
NOTE The Reset button on switchers with matrix sizes of 24 x 12 and above
have a different appearance and do not have a rear panel Reset LED.
Release, then immediately
press and release again.
IP Settings
Reset
6 seconds
Absolute Reset
9 seconds
Press and hold
the Reset button.
3 seconds
Events Reset
Front panel I/O buttons flash once.
Reset LED flashes once.
Release, then immediately
press and release again.
Reset LED flashes twice.
Press and hold
the Reset button.
Press and hold
the Reset button.
Reset LED flashes
three times.
Front panel I/O buttons flash twice.
Front panel I/O buttons flash three times.
RESET
Figure 3-82 — Whole switcher and absolute resets
2 . Release the Reset button and then immediately press and release the Reset
button again. Nothing happens if the second momentary press does not occur
within 1 second.