Quick start, Snap lab system setup – DNP DS-Tmini Kiosk Order Terminal User Manual
Page 11
Photo Editing Software User Manual
11
Quick Start
Snap Lab System Setup
Before you start working with the Photo Editing Software, connect and switch on the DS620 printer and the
Wi-Fi router (PhotoPrints.) Then, turn on the Snap Lab (push the button rear side of the terminal). The Photo
Editing Software will automatically display only products that can be printed with connected printers and
loaded media when DS620 printer is connected (please, refer to the installation guide).
If the DS620 printer is not connected, the software will display the following message:
When the printer is connected to the system, the above message will disappear automatically within a few
seconds, and the software will display the available products as per the connected printer.