RED DIGITAL CINEMA V-RAPTOR 8K VV DSMC3 Camera (RF, Black) - Manual (Page 25)

COMPATIBLE LENSES
The latest RED-tested and approved lenses are listed on the V-RAPTOR 8K VV section of RED Support .
LENS WEIGHT AND LENS SUPPORT
Use a lens support system when mounting heavy or long lenses to your camera.
When mounting a heavy or long lens, ensure that the full weight of the lens is never directly on the camera or lens
mount. Mount the lens to the support system first, and then carefully mount the lens to the camera.
COMPATIBLE MOUNT ADAPTORS
RED tested the following adaptors and determined that they are compatible with the camera:
Canon Mount Adaptor EF-EOS R
Canon Drop-In Filter Mount Adaptor EF-EOS R with Variable ND Filter / Clear Filter / Circular Polarizer
Refer to the V-RAPTOR 8K VV section of RED Support for more information.
ATTACHING LENSES
1. Unlock the locking ring by rotating it to the fully counterclockwise position.
2. Press and hold the lens release button on the camera. While holding the lens release button, turn the camera lens
mount cap counter-clockwise until it stops, and remove it from the camera. If the lens locking ring rotates while
removing the cap, make sure that you hold the locking ring tab in place while rotating the cap.
3. Remove the rear lens cap from the mount end of the lens.
4. Align the red dot on the lens mount with the red dot on the camera lens mount, and insert the lens mount of the lens
in the camera lens mount opening.
5. Turn the lens clockwise until it clicks in place. If the lens locking ring rotates while attaching the lens, make sure that
you hold the locking ring tab in place while rotating the lens or adaptor.
6. Gently tighten the locking ring. DO NOT OVER-TIGHTEN THE LOCKING RING.
7. Store the camera lens mount cap and the rear lens cap together in a dust free location.
REMOVING LENSES
1. Loosen the locking ring gently.
2. Press and hold the lens release button on the camera. While holding the lens release button, turn the lens counter-
clockwise until it stops, and remove it from the camera. If the lens locking ring rotates while removing the lens, make
sure that you hold the locking ring tab in place while rotating the lens or adaptor.
3. Align the red dot on the camera lens mount cap with the red dot on the camera lens mount, and attach the cap to
the camera.
4. Gently tighten the locking ring. DO NOT OVER-TIGHTEN THE LOCKING RING.
5. Attach the rear lens cap to the lens.
6. Store the lens with the front and rear caps attached.
COPYRIGHT © 2021 RED.COM, LLC 955-0198, V1.1, REV. A | 18
V-RAPTOR™ 8K V V OPERATION GUIDE