V-raptor™ 8k v v operation guide – RED DIGITAL CINEMA V-RAPTOR 8K VV DSMC3 Camera (RF, Black) User Manual
Page 103
BNC ATTACHMENT INSTRUCTIONS
When attaching SDI accessories:
1.
Connect a power source to the SDI accessory; power on the SDI accessory.
2.
Ensure a power source is connected to the camera. This ensures both are grounded prior to connecting the BNC.
The camera's power state does not have an impact on SDI attachment sequence.
3.
Connect the BNC cable to the accessory, then to the camera.
When detaching an accessory mounted to an SDI output, ensure that you remove the BNC connection to the camera
before removing power to the SDI device:
1.
Shutdown the SDI accessory.
2.
Disconnect the BNC cable from the camera.
3.
Disconnect the power source from the SDI accessory.
When you need to swap out a battery on an accessory mounted to the camera’s SDI port, you must:
1.
Shutdown the SDI accessory.
2.
Disconnect the BNC cable from the camera.
3.
Replace the battery on the SDI accessory.
4.
Connect the BNC cable to the camera.
5.
Power on the SDI accessory.
For more information, refer to
.
For more information, refer to:
The SDI standard: SMPTE (Society of Motion Picture and Television
Engineers) standard SMPTE ST-2082
STANDARD DYNAMIC RANGE
Standard-dynamic-range (SDR) video describes images or video using a conventional gamma curve signal.
HIGH DYNAMIC RANGE
High-dynamic-range (HDR) video images are recorded using the SMPTE-2084 PQ curve. This technology captures and
outputs a greater range of luminance than images recorded using standard-dynamic-range (SDR) methods.
COPYRIGHT © 2021 RED.COM, LLC
955-0198, V1.1, REV. A | 96
V-RAPTOR™ 8K V V OPERATION GUIDE