RED DIGITAL CINEMA V-RAPTOR 8K VV DSMC3 Camera (RF, Black) - Manual (Page 222)

EXTENSION PORT
The female 9-contact 0B ODU Extension port supports serial (RS-232 RX and TX), a General
Purpose Input (GPI) trigger (active-low switch closure), General Purpose Output (GPO),
Timecode, and Genlock. The connector also offers auxiliary 5 Volt power out, with a maximum
sustained current draw of 500 mA.
To operate the GPI contact closure style trigger, short Pin 6 (GPI) to Pin 9 (ground).
Figure: Front face of the female 9-contact Extension port (looking at the back of the camera).
NOTE: The required mating connector is 9-Pin 0L Straight Plug Connector (ODU, part# SX0L0X-
P09MCC0-0001).
9-PIN 0B ODU EXTENSION PORT PINOUT
PIN SIGNAL DETAILS
1 5 V AUX 5 Volt AUX (500 mA Max) enabled using the Power menu
2 Timecode Out Timecode Out – SMPTE 12M 1
3 GPO General Purpose Out, Sensor Sync, 3.3 Volt Logic Level
4 UART TX Serial RS-232 Transmit
5 UART RX Serial RS-232 Receive
6 GPI General Purpose In, 3.3 Volt Logic Level
2
7 Timecode In Timecode In – SMPTE 12M
8 Genlock Tri-Level Genlock In (SMPTE 296M and 274M)
9 GND Signal and Power Ground
1. Not currently supported.
2. The signal path includes a resistor pulling the signal high, which is designed to work with a closure switch connected to GND.
COMPATIBLE CABLES
790-0685 : RED 9-Pin EXT to Flying Lead 1.3’
790-0674 : RED EXT to Timecode 3'
COPYRIGHT © 2021 RED.COM, LLC 955-0198, V1.1, REV. A | 215
V-RAPTOR™ 8K V V OPERATION GUIDE