Edgecode, V-raptor™ 8k v v operation guide – RED DIGITAL CINEMA V-RAPTOR 8K VV DSMC3 Camera (RF, Black) User Manual

Page 198

EDGECODE

Edgecode only advances while the camera is recording frames. Each frame is sequential. When the media is replaced,
the new media starts the timer over. You can set the Edgecode timer manually by using Secure Format (refer to

Secure

Format

for more information).

SETTING UP EDGECODE TIMECODE

To set up Edgecode Timecode on the camera, perform the following:

1. Open the Audio / Timecode menu:

Menu

Audio / TC

2. Navigate down to Timecode Display Mode:

3. Press SEL to select Timecode Display Mode. The Timecode Display Mode menu opens:

4. Select Edge and press the button under OK to use Edgecode. The camera displays the Edgecode on the

LCD

Home

page:

NOTE:

Each new media card will default to an edgecode track starting at 01:00:00. You can change the edgecode to

begin at any desired time by using the Media Format menu (refer to

Edgecode

955-0198, V1.1, REV. A | 191

V-RAPTOR™ 8K V V OPERATION GUIDE