V-raptor™ 8k v v operation guide – RED DIGITAL CINEMA V-RAPTOR 8K VV DSMC3 Camera (RF, Black) User Manual
Page 102

Advanced mode displays the following:
TOP
BOTTOM
• Camera Number
• Recording Frame Rate
• f-Stop
• Focus Length
• Shutter Angle
• ISO
• White Balance
• Clip Name
• Exposure Meter
• Histogram
• CFexpress Time Remaining
• Temp / Exp Calibration
• Timecode, Genlock, Synch
• DC-In, Battery
• Format, File Type, Rate
• VU Meter
• Timecode
When the camera is recording, the Timecode turns red, and a red dot appears in the top right corner.
SDI PORT DESCRIPTION
The Serial Digital Interface (SDI) ports allow the camera to deliver 12 Gbps of image bandwidth with greater resolution,
frame rates, and color fidelity. These ports allow you to use a single BNC cable solution ideal for 4Kp60 format.
WARNING:
Under certain circumstances, it is possible for an SDI connector to incur damage when connected to an
accessory and powered without using shielded cables. RED recommends only using high quality, shielded BNC cables
that are rated for 12G-SDI signals and only using shielded power cables for powering SDI accessories.
Make sure power is connected to the SDI accessory at all times before you connect the BNC to the camera.
Ungrounded power from SDI accessories can damage the camera’s SDI port. To avoid this possible damage, attach the
power source to the accessory before attaching it to the BNC cable. When using RED Approved Third Party battery
plates, unplug the BNC cable prior to hot swapping.
When possible, avoid using P-Tap (also known as D-Tap) cables to power accessories. To avoid damage when using P-
Tap/D-Tap, it’s imperative that the connect/disconnect sequence (below) is followed precisely.
COPYRIGHT © 2021 RED.COM, LLC
955-0198, V1.1, REV. A | 95
V-RAPTOR™ 8K V V OPERATION GUIDE