Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) - Manual (Page 96)

Studio Display
073-00335-A | 96 © 2022 Apple Inc. All rights reserved.
9. Position the right fan flex
cable in the housing.
10. Slide the end of the right fan
flex cable into the connector
on the logic board. Use the
black stick to flip down the
locking lever. Then press the
polyester film tab to adhere
it to the end of the flex
cable.
11. Run the flat end of the black
stick along the length of the
right fan flex cable to adhere
it to the housing.
12. Follow the reassembly steps
to reinstall the right fan .
13. Position the display
backlight cable in the
housing.
14. Slide the two ends of the
display backlight cable into
the connectors on the logic
board.
15. Run the flat end of the black
stick along the length of the
display backlight cable to
adhere it to the housing.
Cables | Reassembly