Reassembly – Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) User Manual

Page 104

Studio Display

073-00335-A | 104

Reassembly

2. Insert the Torx T5 bit into

the 10–34 Ncm adjustable

torque driver. Set the torque

value to 14.5 Ncm. Use the

adjustable torque driver and

Torx T5 bit to fully reinstall

the four T5 screws in the

order shown.

3. Use the T5 screwdriver to

partially reinstall one T5

grounding screw (923-

07145) into the power cord

port as shown. Keep the

Torx T5 bit in the 10–34

Ncm adjustable torque

driver. Set the torque

value to 25 Ncm. Use the

adjustable torque driver

and Torx T5 bit to fully

reinstall the T5 screw.

1. Position the power cord

port in the housing. Use the

T5 screwdriver to partially

reinstall four T5 screws

(923-07146) into the

power cord port in the order

shown.

Power Cord Port | Reassembly

4. Install the 4 mm alignment

pin in the upper left screw

hole in the left side of the

housing (1). Then install the

3 mm alignment pin in the

upper right screw hole (2).