Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) - Manual (Page 85)

Studio Display
073-00335-A | 85 © 2022 Apple Inc. All rights reserved.
11. Position the DC power
supply board in the
housing. Then use the T8
screwdriver to partially
reinstall four T8 screws
(923-07143) as shown.
12. Keep the Torx T8 bit in
the 0.3–1.2 Nm adjustable
torque driver. Ensure that
the torque value is still set to
0.8 Nm.
Power Supply Boards | Reassembly
13. Use the adjustable torque
driver and the Torx T8 bit
to fully reinstall the four T8
screws.
14. Remove the two alignment
pins. Then use the T8
screwdriver to partially
reinstall two T8 screws
(923-07143) into the DC
power supply board.
15. Keep the Torx T8 bit in
the 0.3–1.2 Nm adjustable
torque driver. Ensure that
the torque value is still set to
0.8 Nm.
16. Use the adjustable torque
driver and the Torx T8 bit
to fully reinstall the two T8
screws.