Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) - Manual (Page 52)

Studio Display
073-00335-A | 52 © 2022 Apple Inc. All rights reserved.
3. Use the T6 screwdriver to
partially reinstall three T6
screws (923-07142) as
shown.
6. Remove the two 2 mm
alignment pins. Then use
the T6 screwdriver to
partially reinstall two T6
screws (923-07142)
as shown.
Logic Board | Reassembly
8. Use the adjustable torque
driver and the T6 bit to fully
reinstall the two T6 screws.
5. Use the adjustable torque
driver and T6 bit to fully
reinstall the three T6
screws.
7. Keep the Torx T6 bit in
the 0.3–1.2 Nm adjustable
torque driver. Ensure that
the torque value is still set to
0.4 Nm.
4. Insert the Torx T6 bit into
the 0.3–1.2 Nm adjustable
torque driver. Set the torque
value to 0.4 Nm.