Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) - Manual (Page 101)

Studio Display
073-00335-A | 101 © 2022 Apple Inc. All rights reserved.
Removal
1. Use the T6 screwdriver to
remove the two T6 screws
(923-07141) from the power
supply bus bar. Remove
the bus bar and save it for
reassembly.
Power Cord Port | Removal
2. Pinch the sides of the end
of the power supply signal
cable and slide it out of the
connector on the power
factor controller (PFC)
power supply board.
Ensure that the support wedge is between the housing and the stand to keep the display in place.
Important