Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) User Manual

Page 84

Studio Display

073-00335-A | 84

Power Supply Boards | Reassembly

9. Install the 3 mm alignment

pin in the upper left screw

hole in the right side of the

housing (1). Then install the

4 mm alignment pin in the

upper right screw hole (2).

10. Turn over the DC power

supply board to reinstall

the original power supply

signal flex cable. Slide the

end of the flex cable into

the connector. Use the flat

end of the black stick to

flip down the locking lever.

Then press the polyester

film tab to adhere it to the

flex cable.

If you’re replacing the

power supply boards,

continue to step 10. If you

removed the power supply

boards as part of another

procedure, skip to step 11.

Important