Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) - Manual (Page 105)

Studio Display
073-00335-A | 105 © 2022 Apple Inc. All rights reserved.
5. Slide the power cord port
cable into the connector on
the back of the PFC power
supply board.
7. Use the T8 screwdriver to
partially reinstall four T8
screws (923-07143) as
shown.
Power Cord Port | Reassembly
6. Align the upper left and
upper right screw holes of
the PFC power supply board
over the two alignment pins.
8. Insert the Torx T8 bit into
the 0.3–1.2 Nm adjustable
torque driver. Set the torque
value to 0.8 Nm. Use the
adjustable torque driver and
Torx T8 bit to fully reinstall
the four T8 screws.