Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) - Manual (Page 106)

Studio Display
073-00335-A | 106 © 2022 Apple Inc. All rights reserved.
9. Remove the two alignment
pins (1, 2). Then use the
T8 screwdriver to partially
reinstall two T8 screws
(923-07143) into the PFC
power supply board (1, 2).
10. Keep the Torx T8 bit in
the 0.3–1.2 Nm adjustable
torque driver. Ensure that
the torque value is still set
to 0.8 Nm.
11. Use the adjustable torque
driver and Torx T8 bit to fully
reinstall the two T8 screws.
Power Cord Port | Reassembly
12. Slide the end of the power
supply signal cable into
the connector on the PFC
power supply board.