Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) User Manual

Page 35

Studio Display

073-00335-A | 35

Display (VESA Mount Adapter) | Before You Begin

• To remove the display, you must cut adhesive strips that attach the display to the rear housing.

Each strip has a foam layer surrounded by two adhesive layers. You’ll use the adhesive cutter to

cut the adhesive strips and will be cutting mostly through the foam layer.

• For models configured with the tilt-adjustable stand or tilt- and height-adjustable stand, refer to

removal and reassembly instructions.

Important

Damaged wheel New wheel

The adhesive cutter has

replacement wheels.

You will likely need to

use several wheels

because when a wheel is

chipped, dented, broken,

or no longer flat, you

must replace it. Using

a damaged wheel can

damage the polyester

tape on the display.

Caution

Note: The images in this procedure may show a display with a stand. However, the procedure is the

same for a display with a VESA mount adapter.

This procedure requires System Configuration. To perform System Configuration you will need the

following:

• The latest version of

installed on a Mac running macOS 12.4 or later

• Internet access

• A USB-C charge cable or a USB-A to USB-C cable. The USB-C cable must support both power

and data. Don’t use Thunderbolt 3 cables.

After you’ve completed all removal and reassembly steps and configured the Mac with Apple

Service Utility, learn how to initiate the System Configuration process at

Caution