Apple 27" Studio Display (Nano-Texture Glass, Tilt Adjustable Stand) - Manual (Page 126)

Studio Display
073-00335-A | 126 © 2022 Apple Inc. All rights reserved.
6. Use the adjustable torque
wrench and 20IP bit to fully
reinstall the right 20IP screw
to 2.9 Nm.
Tilt- and Height-Adjustable Stand | Reassembly
8. Keep the 20IP bit in the
2.5–25 Nm adjustable
torque wrench. Ensure that
the torque value is still set to
2.9 Nm.
9. Use the adjustable torque
wrench and 20IP bit to
partially reinstall the two
20IP screws to 2.9 Nm in
the order shown.
7. Remove the two alignment
pins. Use the adjustable
torque wrench and 20IP
bit to partially reinstall two
20IP screws (452-07329) in
place of the alignment pins
in the order shown.
Note: The alignment pins
may get stuck. If they do,
use a flathead screwdriver
to remove the alignment
pins.