Epson SureLab D1070 Professional Minilab Printer - Manual (Page 76)

SL-D1000 Series User's Guide
Maintenance
76
10
If you are replacing it at the end of its service life,
then, in the control panel screen, select
Settings
- Maintenance , and execute Reset Counter .
The amount that has been fed from the cassette
is reset. You can confirm the amount that has
been fed from the cassette in Maintenance Tool.
Cleaning the Feed Rollers and
Transfer Rollers
When to clean
Clean the feed rollers and transfer rollers together at
the following times.
When paper feed trouble repeatedly occurs and one
of the following messages is displayed on the
control panel screen
O Paper jammed in Inside. Remove the jammed
paper.
O Paper jammed in Cassette. Remove it.
The paper feed trouble described above may occur if
the feed rollers or transfer rollers are dirty, such as with
paper dust. Clean the rollers according to the next
section.
See the following for details on troubleshooting paper
feed trouble.
U “When Paper Jams” on page 144
Item Prepared
Use a soft commercially available cloth to clean the
rollers. Prepare this in advance. We recommend using
a cloth that is low-lint and anti-static.
How to Clean the Feed Rollers
1
Remove the A and B feed rollers.
See the following for the removal procedure.
U “Replacing Feed Rollers” on page 72
2
Use a soft cloth that has been dipped in water
and carefully wrung out to wipe any dirt, such as
paper dust, off of the feed rollers.
A feed roller
Wipe off any dirt stuck to the surface of the
roller in the illustration.
B feed roller
Wipe off any dirt stuck to the surfaces of the
rollers
A and B in the illustration.
The
C
roller does not need to be wiped.
Rotate both rollers A and B to wipe their entire
surfaces. Rotating the part shown in the
illustration rotates the rollers.
c
Important:
Do not wipe the rollers with a dry cloth.
This could scratch the surface of the rollers.