Epson SureLab D1070 Professional Minilab Printer - Manual (Page 22)

SL-D1000 Series User's Guide
Before Use
22
Notes on storage
O Do not throw away the paper packaging as you can use it for storing the paper.
O Avoid locations that are subject to direct sunlight, excessive heat, or humidity.
O Keep cut sheets in their original package after opening, and keep them in a flat place.
O Remove roll paper that is not in use from the spindle unit. Rewind it correctly and then store it in the original
packaging that came with the roll paper. If you leave the roll paper in the printer for a long time, its quality may
decline.
O We recommend removing roll paper from the printer if you are continuously using cut sheets. The back side of
the roll paper may become dirty due to the increased amount of ink mist inside the printer, which sticks to the
back of the roll paper. However, if
Auto Nozzle Check Settings is set to High quality , then leave the roll paper
loaded. In this case, it will be become dirty because check patterns are periodically printed on the roll paper.
Notes on Printing
Make sure that the leading edge of the paper is perpendicular to the long side and cut completely straight.
Storing and displaying printouts
O Make sure you do not rub or scratch the printed side.
O Make sure the print outs are completely dry before folding of stacking; otherwise, the color may change where
they touch (leaves a mark). These marks will disappear if they are separated immediately and dried; however,
they will remain if not separated.
O Do not use a dryer to dry the print outs.
O Avoid locations that are subject to high temperature, humidity, and direct sunlight, and store in a dark place.
O Avoid displaying print outs outdoors or in direct sunlight. This may accelerate the fading.
O When displaying print outs indoors, we recommend placing them in glass frames and so on. This allows you to
display your print outs for a long time without them fading.
Notes on Handling Ink Supply Units
O Store the ink supply units away from direct sunlight at room temperature.
O To ensure print quality, we recommend using all the ink before the earlier of the following dates:
O Recommended use-by-date printed on the package of the ink supply unit
O Within one year after installing the ink supply unit to the printer.
O If ink supply units have been stored in a cold place for a long time, leave them at room temperature for more
than 3 hours before use.
O The ink level and other data are stored in the IC chip, allowing ink supply units to be used after being removed
and replaced.