Epson SureLab D1070 Professional Minilab Printer - Manual (Page 166)

SL-D1000 Series User's Guide
Appendix
166
Roll Paper
Cut sheet
*1 Name selected in the paper type settings in the menus on the printer and the printer driver.
*2. Supported paper widths: 3.5, 4, 5, 6, 8, and 8.26 in (89, 102, 127, 152, 203, 210 mm)
*3 Not supported in the cassette. Print on it from the rear paper feed slot.
Moving and Transporting the Printer
This section describes how to move and transport the product.
Moving the Printer
This section explains how to move the printer over short distances, such as to a different location within the same
building.
General name of
paper
Name of paper
*1
Borderless Printing ICC profile
Matte photo paper Photo Paper(Matte) Epson_SL-D1000_PhotoPaperMatte.icc
General name of
paper
Name of paper *1
Two-side
d Printing
Borderles
s
Printing
*
2
ICC profile
Matte photo paper Photo Paper(Matte) Epson_SL-D1000_PhotoPaperMatte.icc
Glossy photo
paper Photo Paper(Glossy) - Epson_SL-D1000_PhotoPaperGloss.icc
Card stock Card Stock(Plain) Epson_SL-D1000_Standard.icc
Glossy card stock *3 Card Stock(Coated) - Epson_SL-D1000_Standard.icc
!
Caution:
O When lifting this printer, make sure you use the correct posture.
O When lifting the product, place your hands in from the front of the printer as shown in the manual.
If you hold any other areas, the printer may fall or your fingers could be trapped and damaged when placing
the printer.
O Do not tilt the product more than 10 degrees forward, back, left, or right while moving it. Failure to observe this
precaution could result in the printer falling over, causing accidents.
c
Important:
O Only hold the required area. Otherwise, it may breakdown.
O Move the printer while the ink supply units are installed. If the ink supply units are removed, the nozzles may
clog so printing is not possible or ink may leak.
O Do not tilt the product when moving or transporting it. Ink could leak out.