If none of the above, Restoring factory defaults, Diagnostics – Kurzweil Forte User Manual
Page 351: If none of the above -7, Restoring factory defaults -7 diagnostics -7, Service centers
Troubleshooting
If None of the Above...
15-7
If None of the Above...
If your problem is not covered above, or if none of the suggestions seem to work, first check
back and review the relevant sections of this manual. Many difficulties are just programming
problems caused by settings of Multi parameters. If you want to be sure that all of the factory
defaults are in place, see the
Also be sure to check Kurzweil’s website for additional Forte information that may have been
published since this manual was written: www.kurzweil.com.
If you still have problems, contact Kurzweil support in your country or at www.kurzweil.
com/support/. You may also find unofficial help at some of the internet communities listed at
www.kurzweil.com/community/.
Service Centers
Contact the nearest Young Chang office Kurzweil service representative. See
front of this manual for contact information.
Restoring Factory Defaults
For restoring your Forte back to the factory defaults, see Global Mode Reset on
CAUTION: Restoring factory defaults cannot be undone. Back up
your files before doing so by using Storage mode; see “Store All”
on page 11-6.
Diagnostics
You will most likely not need to use the System Mode diagnostic operations in normal
cases. These operations are mostly used at the factory and service centers by engineers for
troubleshooting hardware problems. But, in some cases you might be required to run these
diagnostics for troubleshooting and diagnosing symptoms. In these cases, follow the direction
of an authorized Kurzweil technician.