Kurzweil Forte - Manual (Page 186)

Program Edit Mode
KB3 Editor: The PITCH Page
7-89
Tune
This parameter lets you tune each of the nine drawbars up or down in semitone steps. The
values for the Tune parameter on the Drawbars page shown above represent standard drawbar
settings on a real B3, as shown in the table below.
Subharmonics Fundamental Harmonics
16’ 5 1 /3’ 8’ 4’ 2 2 /3’ 2’ 1 3 /5’ 1 1 /3’ 1’
Slider A Slider B Slider C Slider D Slider E Slider F Slider G Slider H Slider I
Figure 7-2 Standard Drawbar Settings for the Hammond B3
KB3 Editor: The PITCH Page
The PITCH page parameters for KB3 programs are similar to the Pitch parameters for VAST
programs on the DSPMOD page. (In KB3 programs, there are no Hz, KeyTrk, or VelTrk
parameters.) Use the Coarse and Fine parameters to transpose the entire program up or
down in semitones or cents. The parameters in the right column can be used to modulate
the pitch, and work the same as the “Pitch” modulation parameters in VAST programs. For
a full description of these modulation source and depth parameters, see “Programmable
Parameters” on page 7-38 .