Kurzweil Forte - Manual (Page 139)

Program Edit Mode
The DSP Control (DSPCTL) Page
7-42
DSP Control Page Parameters
Function Parameter Range of Values Default
Pitch
Pitch -128 to 127 semitones 0
Fine Adjust ± 100 cents 0
Hertz Adjust ± 10.00 Hertz 0
Key Tracking ± 2400 cents/key 0
Velocity Tracking ± 7200 cents 0
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
Level
Level -96 to 24 decibels -6
Key Tracking ± 2.00 decibels/key 0
Velocity Tracking ± 96 decibels 35
Each field in the left-hand column of the page is a function-parameter of the current layer’s
algorithm. You can coarsely adjust the function-parameter in these left-hand fields—as noted
in Common DSP Control Parameters on page 7-35 , any adjustments made to the function-
parameters on the DSPCTL page are reflected in the corresponding function-parameters
on the DSPMOD page. The right-hand side of the DSPCTL page is the subpage of the
highlighted function-parameter—on the subpage are the fine adjust parameters and hard-
wired parameters. To access the parameters on the subpage, highlight the function-parameter
you wish to edit, and then press the > button to move the cursor into the subpage. The label
of a function-parameter depends on its corresponding function-block in the current layer’s
algorithm.