PLANET MH-2300 User Manual
Page 43
Gigabit Multi-Homing VPN Security Gateway
MH-2300
43
HTTPS
When ticked, the management interface is available for access via HTTPS
protocol.
Telnet
When ticked, the management interface is available for access via Telnet
protocol.
SSH
When ticked, the management interface is available for access via SSH
protocol.
WAN Connection Type (only configurable for WAN)
There are three connection types:
Static IP Address (Leased Line User)
Dynamic IP Address (Cable Modem User)
PPPoE (ADSL Dial-up User)
Keepalive Properties Type
The two verification methods for Internet availability are listed as follows:
ICMP: Verifies the Internet availability by pinging a specific IP address.
DNS: Verifies the Internet availability by requesting a specific domain
name.
NAT Redirection
Translates private IP addresses into public addresses.
Auto-configuration: The public address is automatically designated
to the IP address of an active WAN link.
A designated IP: The public address is manually designated to the IP
address of an available WAN link.
Max. Downstream & Upstream Bandwidth
Specify a proper bandwidth separately for downstream and upstream
operations.
Disconnect if idle for…minutes
Specify an idle timeout to automatically disconnect the Internet via PPPoE
dial-up connection. Type “0” to stay connected or a value from 1 to 99,999
(time unit: minute) for disconnection.
DMZ Connection Type (only configurable for DMZ)
Please refer to “
LAN
Connection Type
”.
Saturated Connections
Determines the maximum sessions allowed for each WAN interface when
running in By Traffic, By Session or By Packet mode. New sessions will
be distributed to other WAN interfaces when the value has been exceeded