PLANET WGSD-1022 - Manual (Page 68)

The Page contains the following fields:
• Select QoS Mode This indicates if QoS is enabled on the interface. The possible values
are:
• Disable, disables QoS on the interface.
• Port Qos, enables QoS on the interface.
• Policy Qos, enables the Advanced Mode QoS on the interface.
• Class of Service Specifies the CoS priority tag values, where zero is the lowest and 7
is the highest
• Queue Defines the traffic forwarding queue to which the CoS priority is
mapped.
Four traffic priority queues are supported
The Restore Defaults button restores the device factory defaults for mapping CoS values to a
forwarding queue.
„ 802.1p Default:
The Table contains the following fields:
• Port# Interface to which the CoS configuration applies
• Default CoS Determines the default CoS value for incoming packets for which a
VLAN tag is not defined. The possible field values are 0-7.
The default CoS is 0
• Restore Defaults Restores the device factory defaults for mapping CoS values to
forwarding queue.
• LAG LAG to which the CoS configuration applies.