8 show sessions, 9 show system, Syntax – PLANET WGSD-1022 User Manual
Page 294: Default configuration, Command mode, User guidelines, Examples

5.23.8 show sessions
The show sessions command in EXEC mode lists the open Telnet sessions.
Syntax
show sessions
This command has no arguments or keywords.
Default Configuration
There is no default configuration for this command.
Command Mode
EXEC mode
User Guidelines
There are no user guidelines for this command.
Examples
The following table describes the significant fields shown in the display:
Console> show sessions
Connection Host Address Port Byte
---------------- ------------- ------------- -------- -------
1 Remote router 172.16.1.1 23 89
2 172.16.1.2 172.16.1.2 23 8
Field
Description
Connection
Connection number
Host
Remote host to which the device is connected through a Telnet session.
Address
IP address of the remote host.
Port
Telnet TCP port number
Byte
Number of unread bytes for the user to see on the connection.
5.23.9 show system
The show system user EXEC command displays system information.
Syntax
show system
Default Configuration
This command has no default configuration.