PLANET WGSD-1022 - Manual (Page 223)

port-default settings. An error message is generated; however, it is important to note that, since it is then
the ONLY port of the LAG, the whole LAG at that point operates at the port’s settings, instead of the LAG
administrative settings.
Example
The following example shows how port e5 is configured to port-channel number 1 without LACP.
Console (config)# interface ethernet e5
Console (config-if)# channel-group 1 mode on
5.15.4 show interfaces port-channel
The show interfaces port-channel user EXEC command displays port-channel information (which ports
are members of that port-channel, and whether they are currently active or not).
Syntax
show interfaces port-channel [port-channel-number]
ƒ port-channel-number — Valid port-channel number information to display.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how all port-channel information is displayed.
Console (config)# show interfaces port-channel
Channel Ports
------------ -----------------
ch1 Active: g2
ch2 Active: e3, e7 Inactive: g1
ch3 Active: e4, e8