PLANET WGSD-1022 - Manual (Page 37)

4.3 Port Configuration
In this field, you can see these parts, such as Port settings, Link aggregation, LACP Config.
4.3.1 Port Settings
To use the port settings screen for setting up each of the Switch’s ports. It shows these parts: port#,
memo, admin control, link status, current speed, duplex mode, MDI/MDIX, Flow control, Phy type, LAG,
PVE (see Figure 4-6):
Figure 4-6 Port Settings screen
The Port Settings screen contains the following fields:
• Port Shows the port number. You can click on the Detail button of the
appropriate port (G1, G2) to use an SFP module, and the Detail
button shows the Port Configuration Detail screen, which include port,
description, port type, admin status, current port status ……
• Memo
Click up the Detail button to make a brief description of the port
• Admin Control When to choose the UP button, the port can be accessed normally, to
choose the Down button, the port will be taken offline
• Link Status
Shows an active connection when you choose the UP button, there is
no active connection or the port has been taken offline by an
Admiinistrator when you choose the Down button
• Current Speed
Shows the connection speed of the port and the speed can be