PLANET WGSD-1022 - Manual (Page 195)

5.9.4 ip igmp snooping host-time-out
The ip igmp snooping host-time-out interface configuration command configures the host-time-out. If
an IGMP report for a multicast group was not received for a host-time-out period, from a specific port, this
port is deleted from the member list of that multicast group. To reset to default host-time-out use the no
form of this command.
Syntax
ip igmp snooping host-time-out time-out
no ip igmp snooping host-time-out
Default Configuration
The default host-time-out is 260 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
The timeout should be at least greater than 2*query_interval+max_response_time of the IGMP router.
Example
The following example configures the host timeout to 300 seconds.
Console (config)# interface vlan 2
Console (config-if)# ip igmp snooping host-time-out 300
5.9.5 ip igmp snooping mrouter-time-out
The ip igmp snooping mrouter-time-out interface configuration command configures the
mrouter-time-out. The mrouter-time-out command is used for setting the aging-out time after multicast
router ports are automatically learned. To configure the default mrouter-time-out, use the no form of this
command.
Syntax
ip igmp snooping mrouter-time-out time-out
no ip igmp snooping mrouter-time-out
ƒ time-out—mrouter timeout in seconds (Range: 1 - 2147483647)
Default Configuration
The default value is 300 seconds.