PLANET WGSD-1022 - Manual (Page 289)

ƒ keyword — Can be one or more keywords from the keywords table in the User Guidelines.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
The Telnet software supports special Telnet commands in the form of Telnet sequences that map generic
terminal control functions to operating system-specific functions. To issue a special Telnet command,
enter Esc and then a command character.
If you want to login to host on the out-of-band port, use the out-of-band IP address format:
oob/ip-address.
Special Telnet Command character
Escape Sequence Purpose
Ctrl-shift-6 b Break
Ctrl-shift-6 c Interrupt Process (IP)
Ctrl-shift-6 h Erase Character (EC)
Ctrl-shift-6 o Abort Output (AO)
Ctrl-shift-6 t Are You There? (AYT)
Ctrl-shift-6 u Erase Line (EL)
At any time during an active Telnet session, the Telnet commands can be listed by pressing the
Ctrl-shift-6 key, followed by a question mark at the system prompt: Ctrl-shift-6 ?
A sample of this list follows.
The following example displays the system service tag information.
Console> ‘Ctrl-shift-6’ ?
[Special telnet escape help]
Esc B sends telnet BREAK
Esc C sends telnet IP
Esc H sends telnet EC
Esc O sends telnet AO
Esc T sends telnet AYT
Esc U sends telnet EL