PLANET WGSD-1022 - Manual (Page 166)

network server using TFTP. Use the copy startup-config destination-url command to copy the "startup
configuration" file to a network server.
The configuration file copy can serve as a backup copy.
Saving the Running Configuration to the Startup Configuration
Use the copy running-config startup-config command to copy the "running configuration" to the
"startup configuration".
Backup the Running Configuration or Startup Configuration to the Backup Configuration
Use the copy running-config file command to backup the running configuration to a backup
configuration file.
Use the copy startup-config file command to backup the startup configuration a backup configuration
file Specifying out-of-band addresses
If you want to copy from/to a server on the out-of-band port use the out-of-band IP address format:
oob/ipaddress.
Example
The following example copies a system image named file1 from the TFTP server with an IP address of
172.16.101.101 to non active image file.
Console# copy tftp://172.16.101.101/file1 image
Accessing file 'file1' on 172.16.101.101...
Loading file1 from 172.16.101.101:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!! [OK]
Copy took 0:01:11 [hh:mm:ss]
Accessing file 'configfile' on oob/172.16.1.1...
Loading file1 from oob/172.16.1.1:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!! [OK]
Copy took 0:0:23 [hh:mm:ss]