PLANET WGSD-1022 - Manual (Page 43)

4.3.3 LACP Config
Aggregated Links can be manually setup or automatically established on the relevant links by enabling
Link Aggregation Control Protocol (LACP).
Aggregate ports can be linked into link-aggregation port-groups. Each group is comprised of ports with
the same speed, set to full-duplex operation. The LACP screen contains fields for configuring LACP LAG
s (see figure 4-10)
Figure 4-10 LACP configuration screen
The page contains the following fields:
• LACP System Priority Indicates the global LACP priority value. The possible range is 1- 65535
and the default value is 1.
• Port# Set the port number which need to timeout and the priority values are
assigned
• LACP Port Priority Where set the LACP priority value for the port and the field range is
1-65535
• LACP Timeout Administrative LACP timeout. A short or long timeout value can be
selected. Long is the default
• Admin Key A channel will only be formed between ports having the same admin
key, in other words, this only applies to ports located on the same switch