PLANET WGSD-1022 - Manual (Page 221)

5.15 Port Channel Commands
5.15.1 interface port-channel
The interface port-channel global configuration command enters the interface configuration mode of a
specific port-channel.
Syntax
interface port-channel port-channel-number
ƒ port-channel-number — A valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
Seven supported aggregated links are defined, and per port-channel, up to 4 member ports.
Turning off auto-negotiation of an aggregate link may, under some circumstances, make it
non-operational. If the other side has auto-negotiation turned on, it may re-synchronize all members of
the aggregated link to half-duplex operation, and may, as per the standards, set them all to inactive.
Example
The following example enters the context of port-channel number 1.
Console (config)# interface port-channel 1
5.15.2 interface range port-channel
The interface range port-channel global configuration command enters the interface configuration
mode to configure multiple port-channels.
Syntax
interface range port-channel {port-channel-range | all}
ƒ port-channel-range — List of port-channels to configure. Separate non-consecutive port-channels
with a comma and no spaces. A hyphen designates a range of port-channels.
ƒ all — All the channel-ports.
Default Configuration
This command has no default configuration.