11 lacp commands, 1 lacp system-priority, 2 lacp port-priority – PLANET WGSD-1022 User Manual
Page 205: Syntax, Default configuration, Command mode, User guidelines, Example

Console# show arp
ARP timeout: 60000 Seconds
Interface IP address HW address status
------------ ------------------------ ------------------ --------
e1 10.7.1.102 00:10:B5:04:DB:4B Dynamic
g2 10.7.1.135 00:50:22:00:2A:A4 Static
5.11 LACP Commands
5.11.1 lacp system-priority
The lacp system-priority global configuration command configures the system priority. To reset to
default, use the no form of this command.
Syntax
lacp system-priority value
no lacp system-priority
value — Value of the priority. (Range: 1 - 65535)
Default Configuration
The default system priority value is 1.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the system priority to 120.
Console (config)# lacp system-priority 120
5.11.2 lacp port-priority
The lacp port-priority interface configuration command configures the priority value for physical ports.
To reset to default priority value, use the no form of this command.