PLANET WGSD-1022 - Manual (Page 48)

The page contains the following fields:
• VLAN Where means the VLAN number
• Access Indicates the port belongs to a single untagged VLAN. When a port is
in Access mode, the packet types which are accepted on the port
cannot be designated. Ingress filtering cannot be enabled/disabled on
an access port.
• Trunk Which indicates the port belongs to VLANs in which all ports are
tagged, except for one port that can be untagged
• General Which indicates the port belongs to VLANs, and each VLAN is
user-defined as tagged or untagged (full 802.1Q mode)
• Tagged Defines the interface as a tagged member of a VLAN. All packets
forwarded by the interface are tagged. The packets contain VLAN
information
• Untagged Packets forwarded by the interface are untagged
• Forbidden Forbidden ports are not included in the VLAN
• Exclude Excludes the interface from the VLAN. However, the interface can be
added to the VLAN through GVRP
4.4.4 GVRP Config
GARP VLAN Registration Protocol (GVRP) is specifically provided for automatic distribution of VLAN
membership information among VLAN-aware bridges. GVRP allows VLAN-aware bridges to
automatically learn VLANs to bridge ports mapping, without having to individually configure each bridge
and register VLAN membership. The Global System LAG information displays the same field information
as the ports, but represents the LAG GVRP information.
The GVRP screen (refer to 4-14) is divided into two areas, GVRP and GVRP Table. The field definitions
for both areas are the same.