PLANET WGSD-1022 - Manual (Page 38)

configured only when auto-negotiation is disabled on that port
• Duplex Mode
The port duplex mode, Full (transmission occurs in both directions
simultaneously) or Half (transmission occurs in only one direction at a
time). This mode can be configured only when auto-negotiation is
disabled and port speed is set to 10Mbps or 100Mbps.
It cannot be configured on Link Aggregation Groups (LAGs)
• MDI/ MDIX
Shows the MDI/MDIX status of the port. To use the MDI setting if the
port is connected to an end station. To use the MDIX setting if the port
is connected to a hub or another switch
• Flow control
Shows the flow control status of the port. It is active when the port
uses Full Duplex Mode
• Phy Type
Shows the port type
• LAG Shows whether the port is part of a LAG
• PVE It bypasses the Forwarding Database and forwards all unicast,
multicast, and broadcast traffic to an uplink when a port is a Private
VLAN Edge (PVE) port, Uplinks can be ports or LAGs
• Edit It will open the port configuration detail screen