PLANET WGSD-8020 - Manual (Page 65)

User’s Manual of WGSD-8020
65
4.2.16 Factory Default
The Factory Reset button can reset the Managed Switch back to the factory default mode. Be aware that the entire configuration
will be reset; only the IP address of the Managed Switch is retained. Once the Factory Reset item is pressed, the screen in
Figure 4-2-25 appears.
Figure 4-2-25 Factory Default page screenshot
The new configuration is available immediately, which means that no reboot is necessary.
Yes : Click to reset the configuration to Factory Defaults.
No : Click to return to the Port State page without resetting the configuration.
After the “Factory” button be pressed and rebooted, the system will load the default IP settings as following:
。 Default IP address: 192.168.0.100
。 Subnet mask: 255.255.255.0
。 Default Gateway: 192.168.0.254
。 The other setting value is back to disable or none.
To reset the Managed Switch to the Factory default setting, you can also press the hardware reset button
at the front panel about 10 seconds. After the device be rebooted. You can login the management WEB
interface within the same subnet of 192.168.0.xx.
Hardware Reset button