PLANET WGSD-8020 - Manual (Page 164)

User’s Manual of WGSD-8020
164
• Host: Sender IP filter is set to Host. Specify the sender IP address in the SIP
Address field that appears.
• Network: Sender IP filter is set to Network. Specify the sender IP address and
sender IP mask in the SIP Address and SIP Mask fields that appear.
•
Sender IP Address
When "Host" or "Network" is selected for the sender IP filter, you can enter a
specific sender IP address in dotted decimal notation.
•
Sender IP Mask When "Network" is selected for the sender IP filter, you can enter a specific sender
IP mask in dotted decimal notation.
• Target IP Filter Specify the target IP filter for this specific ACE.
• Any: No target IP filter is specified. (Target IP filter is "don't-care".)
• Host: Target IP filter is set to Host. Specify the target IP address in the Target IP
Address field that appears.
• Network: Target IP filter is set to Network. Specify the target IP address and
target IP mask in the Target IP Address and Target IP Mask fields that appear.
• Target IP Address When "Host" or "Network" is selected for the target IP filter, you can enter a specific
target IP address in dotted decimal notation.
• Target IP Mask When "Network" is selected for the target IP filter, you can enter a specific target IP
mask in dotted decimal notation.
• ARP SMAC Match Specify whether frames can hit the action according to their sender hardware
address field (SHA) settings.
0 : ARP frames where SHA is not equal to the SMAC address.
1 : ARP frames where SHA is equal to the SMAC address.
Any : Any value is allowed ("don't-care").
• RARP SMAC Match Specify whether frames can hit the action according to their target hardware
address field (THA) settings.
0 : RARP frames where THA is not equal to the SMAC address.
1 : RARP frames where THA is equal to the SMAC address.
Any : Any value is allowed ("don't-care").
• IP/Ethernet Length Specify whether frames can hit the action according to their ARP/RARP hardware
address length (HLN) and protocol address length (PLN) settings.
0 : ARP/RARP frames where the HLN is equal to Ethernet (0x06) and the (PLN)
is equal to IPv4 (0x04) must not match this entry.
1 : ARP/RARP frames where the HLN is equal to Ethernet (0x06) and the (PLN)
is equal to IPv4 (0x04) must match this entry.
Any : Any value is allowed ("don't-care").
• IP Specify whether frames can hit the action according to their ARP/RARP hardware
address space (HRD) settings.
0 : ARP/RARP frames where the HLD is equal to Ethernet (1) must not match
this entry.
1 : ARP/RARP frames where the HLD is equal to Ethernet (1) must match this