PLANET WGSD-8020 - Manual (Page 235)

User’s Manual of WGSD-8020
235
6. Command Line Mode
The CLI groups all the commands in appropriate modes according to the nature of the command. A sample of the CLI command
modes are described below. Each of the command modes supports specific software commands.
Command Groups:
System System settings and reset options
IP IP configuration and Ping
SNMP Simple Network Management Protocol
Port Port management
Aggr Link Aggregation
VLAN Virtual LAN
STP Spanning Tree Protocol
IGMP Internet Group Management Protocol snooping
QoS Quality of Service
Dot1x IEEE 802.1X port authentication
ACL Access Control List
MAC MAC address table
LLDP Link Layer Discovery Protocol
Auth Authentication
DHCP Dynamic Host Configuration Protocol
Privilege Privilege level
ARP Address Resolution Protocol
6.1 System Command
System Configuration
Description:
Show system configuration.
Syntax:
System Configuration [all] []
Parameters:
all : Show all switch configuration, default: Show system configuration
: Port list or 'all', default: All ports