PLANET WGSD-8020 - Manual (Page 158)

User’s Manual of WGSD-8020
158
The page includes the following fields:
Object Description
•
Ingress Port Select the ingress port to which this ACE applies.
• Any: The ACE applies to any port.
• Port n: The ACE applies to this port number, where n is the number of the
switch port.
• Policy n: The ACE applies to this policy number, where n can range from 1
through 8.
•
Switch Select the switch to which this ACE applies.
• Any: The ACE applies to any port.
• Switch n: The ACE applies to this switch number, where n is the number of
the switch.
•
Action Specify the action to take with a frame that hits this ACE.
• Permit: The frame that hits this ACE is granted permission for the ACE
operation.
• Deny: The frame that hits this ACE is dropped.
•
Rate Limiter Specify the rate limiter in number of base units. The allowed range is 1 to 15.
Disabled indicates that the rate limiter operation is disabled.
•
Logging Specify the logging operation of the ACE. The allowed values are:
• Enabled: Frames matching the ACE are stored in the System Log.
• Disabled: Frames matching the ACE are not logged.
• Shutdown Specify the port shut down operation of the ACE. The allowed values are:
• Enabled: If a frame matches the ACE, the ingress port will be disabled.
• Disabled: Port shut down is disabled for the ACE.
Please note that the System Log memory size and logging rate is limited.
The ACL configuration wizard is finished, and the new configuration is ready for use.
Figure 4-10-11 Access Control List Configuration page screenshot