PLANET WGSD-8020 - Manual (Page 194)

User’s Manual of WGSD-8020
194
Access-Request is sent and
decremented due to receipt of an
Access-Accept, Access-Reject,
Access-Challenge, timeout, or
retransmission.
Tx Timeouts radiusAuthClientExtTimeouts
The number of authentication
timeouts to the server. After a
timeout, the client may retry to the
same server, send to a different
server, or give up. A retry to the same
server is counted as a retransmit as
well as a timeout. A send to a
different server is counted as a
Request as well as a timeout.
Other Info
This section contains information about the state of the server and the latest round-trip time.
Name RFC4668 Name Description
State -
Shows the state of the server. It takes one of the following values:
„ Disabled: The selected server is disabled.
„ Not Ready: The server is enabled, but IP communication is not yet
up and running.
„ Ready: The server is enabled, IP communication is up and
running, and the RADIUS module is ready to accept access
attempts.
„ Dead (X seconds left): Access attempts were made to this server,
but it did not reply within the configured timeout. The server has
temporarily been disabled, but will get re-enabled when the
dead-time expires. The number of seconds left before this occurs is
displayed in parentheses. This state is only reachable when more
than one server is enabled.
Round-Trip
Time
radiusAuthClientExtRoundTripTime
The time interval (measured in milliseconds) between the most recent
Access-Reply/Access-Challenge and the Access-Request that
matched it from the RADIUS authentication server. The granularity of
this measurement is 100 ms. A value of 0 ms indicates that there
hasn't been round-trip communication with the server yet.