PLANET WGSD-8020 - Manual (Page 161)

User’s Manual of WGSD-8020
161
4.10.3 ACE Configuration
Configure an ACE (Access Control Entry) on this page. An ACE consists of several parameters. These parameters vary
according to the frame type that you select. First select the ingress port for the ACE, and then select the frame type. Different
parameter options are displayed depending on the frame type that you selected.
A frame that hits this ACE matches the configuration that is defined here.
Figure 4-10-13 ACE Configuration page screenshot
The page includes the following fields:
Object Description
•
Ingress Port Select the ingress port for which this ACE applies.
„ Any: The ACE applies to any port.
„ Port n: The ACE applies to this port number, where n is the number of the
switch port.
„ Policy n: The ACE applies to this policy number, where n can range from 1
through 8.
•
Switch Select the switch to which this ACE applies.
„ Any: The ACE applies to any port.
„ Switch n: The ACE applies to this switch number, where n is the number of the
switch .
•
Frame Type Select the frame type for this ACE.
„ Any: Any frame can match this ACE.
„ Ethernet Type: Only Ethernet Type frames can match this ACE.