TA Triumph-Adler DCC 2725 - Manual (Page 193)

Sending Functions
5-25
5
Enter Document Name/File Name
This setting allows you to assign a document name to scanned images. You can specify a default for the
document name.
Use the procedure below to assign names to scanned documents that you are sending.
1 Press the Send key.
2 Place the originals on the platen.
3 Press [Advanced Setup] and then [File Name
Entry].
4 Press [File Name].
5 Enter the document name, and press [OK].
NOTE: Up to 32 characters can be entered for the
document name.
6 Press [Job No.] to enter the job No., and [Date and
Time] to enter the date and time.
7 Press [OK].
8 Specify the destination, and press the Start key to
start sending.
Add a file name.
Additional information such as Job No.
and Date and Time can also be set.
File Name Entry
File Name
doc
Additional Info
Job No. Date and Time
& [ ] Date and Time
Cancel OK Add Shortcut
Status 08/08/2009 10:10
Place original.
Ready to send. Destination