TA Triumph-Adler DCC 2725 - Manual (Page 190)

Sending Functions
5-22
Continuous Scan
When the multi-page originals cannot be placed in the document processor at one time, the originals can be
scanned in separate batches and then sent as one job. With this function, originals can be scanned one after
another until you press [Scan Finish].
Any of the following settings can be changed during scanning.
• Original Size selection
• Original Orientation
• 1-sided / 2-sided selection
• Scan density
• Image quality
• Scan resolution
• Color selection
• Sending Size selection
• Zoom
• Border Erase
The procedure for using continuous scanning when sending scanned images is explained below.
1 Press the Send key.
2 Press [Advanced Setup] and then [Continuous
Scan].
3 Press [On]. Continuous Scan is selected.
4 Press [OK].
5 Specify the destination.
6 Place the original, and press the Start key.
When the scanning is completed, change the
settings as necessary.
7 Place the next original, and press the Start key.
Scan the remaining originals by the same
procedure.
When you have scanned all the originals, press
[Finish Scan] to start sending.
Continuous Scan
Scan a large number of originals
in separate batches and then produce
as one job.
*Settings can be changed during scanning.
Off On
Cancel OK Add Shortcut
Status 08/08/2009 10:10
Preview
Original
Zoom
Send
100%
---
:
:
: ---
Place original.
Place original.
Ready to send. Destination