Eicon Networks 1550 - Manual (Page 77)

Web Interface Settings Glossary 77
Connection Menu > Connection Group (X.25)
Remote DTE Address
Defines the remote X.25 address the Eicon 1550/1551 calls to establish the
connection.
Range: 1-15 digits.
When the X.25 connection type is set to permanent (see the ‘Connection Type’
setting), this parameter defines the VC number used.
Compression Type
Defines the type of compression used for X.25 traffic.
• NONE: No compression.
• EICON: Compression negotiation: CCP (Compression Control Protocol).
Compression algorithm: LZS-STAC. Check mode: LCB, Sequence number, and
extended mode. Not compatible with Cisco routers.
• BAY: Compression negotiation: WCP. Compression algorithm: Magnalink. Check
mode: LCB. Dictionary size: 8K or 32K.
• CISCO: Compression negotiation: None. Compression algorithm: LZS-STAC. Not
compatible with Eicon mode.
Connection Type
Defines the type of connection that will be established with the remote device.
• TWOWAY: Both the Eicon 1550/1551 and remote device can initiate the connection.
• INCOMING: The remote device must initiate the connection.
• PERMANENT: A PVC is permanently established between two destinations. No call
setup is required.
Facilities
Sets the X.25 facilities used to establish an X.25 call with this profile. Encode facilities
as a hexadecimal string of characters separated by commas, colons, or hyphens.
Maximum length is 14 bytes. For example: 42,07,07